How To Change A Fuel Filter On A 2000 Gmc Yukon Xl

How to Change the Gas Filter on a 2000 Yukon

past Gregory Crews

pumping gas image by Mat Hayward from <a href='http://www.fotolia.com'>Fotolia.com</a>

THe GMC Yukon uses an in-line fuel filter to protect the engine against debris and sediments that may be in the gas tank. In one case the filter gets clogged, it will need to be replaced to ensure the truck gets good fuel economy and utilizes all the power the truck is capable of. The recommended interval for changing out the filter is 30,000 to 40,000 miles. This volition ensure any debris and sediment that may get sucked in the fuel line does not reach the engine.

Step 1

Ensure the Yukon is parked on a apartment and level surface. Open the hood for access to the engine compartment.

Footstep 2

Locate the fuse panel behind the battery. Open the fuse panel by taking off the cover. Take the fuse for the fuel pump out past hand.

Step iii

Start the truck and allow it to idle until it stalls. This will depressurize the fuel system. Turn the ignition to the "Off" position and take the key out. Insert the fuse dorsum in the fuse panel.

Step four

Locate the gas filter under the truck. Follow the fuel line under the truck to the driver-side front door. The filter will exist tucked away, bolted to the frame track.

Stride 5

Unscrew the inlet line with a line wrench. Use a second line wrench to concord the filter notwithstanding. Repeat to remove the outlet line.

Step 6

Unbolt the filter from the frame rail with a socket wrench. Slide the filter out from the mounting bracket.

Step 7

Position the new filter to the bracket and secure it with the socket wrench. The arrow on the filter needs to be pointing toward the front end of the truck; this designates the management of the fuel flow.

Footstep 8

Tighten the fuel lines to the filter with a line wrench. Utilise a second line wrench to agree the filter nonetheless while tightening the line. The filter has a stationary nut for the line wrench to grip.

Step nine

Showtime the truck to broadcast the fuel in the fuel lines. The truck may not start right away, as there is air in the fuel lines. Bleed the air out by turning the ignition to the "Starting time" position and waiting for three seconds. The fuel pump will button fuel in the lines, pushing out the air. One time the air is pushed out of the lines, the truck volition start.

Let the truck to idle for five minutes. Inspect the filter for any leaks.

References

• Automedia: Fuel Filter Swap
• "Chevrolet Silverado and GMC Sierra Haynes Repair Manual for 1999 thru 2006"; John Haynes; 2007

Tips

• Taking off the gas cap and allowing the truck to sit for 4 hours volition likewise help to depressurize the fuel system. Accept a drain pan standing by to catch whatsoever fuel from the fuel lines.

Things You'll Need

• Line wrench set up
• Socket set
• Socket wrench
• New fuel filter

Warnings

• Wear protective eye gear equally fuel can exist hazardous to the optics.

Writer Bio

Gregory Crews has been in the flick manufacture for 3 years and has appeared in more than 38 major motion pictures and 16 television shows. He also writes detailed automotive tutorials. His expertise in the automotive manufacture has given him the skills to write detailed technical instructional articles.

More Manufactures

Source: https://itstillruns.com/change-gas-filter-2000-yukon-6711291.html

Posted by: wellsimeting82.blogspot.com

Share this post